BMW 3 Series E30

since 1983-1994 release

Repair and operation of the car



BMW E30
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engine
+ 4. Cooling system
- 5. Heating and ventilation
   + 5.1.2. Fan of a heater and conditioner
   - 5.2. Air conditioning system
      5.2.2. Care of air conditioning system
      5.2.3. Compressor
      5.2.4. Condenser
      5.2.5. Moisture separator
      5.2.6. Conditioner evaporator
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
+ 11. Running gear
+ 12. Body
+ 13. Electric equipment
+ 14. Useful tips


fb0c4883



5.2.5. Moisture separator

GENERAL INFORMATION

Moisture separator

1. Relay of high pressure
2. Highways of the conditioner
3. Relay of low pressure
4. Socket

On a part of cars the moisture separator is mounted behind a back headlight.

Removal and installation

PERFORMANCE ORDER
1. Depressurize the conditioner and remove coolant in car service.
2. Disconnect the battery from weight.
3. Remove a windshield washer reservoir.
4. Disconnect from wire moisture separator sensors (on a part of cars there can be one sensor of pressure).
5. Unscrew screws and remove a moisture separator.
6. Installation is carried out upside-down. If the new moisture separator is established, then be guided by the instruction attached to this unit, rearrange on it pressure sensors. Replace a sealing ring. Fill system with coolant in car service.