BMW 3 Series E30

since 1983-1994 release

Repair and operation of the car



BMW E30
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engine
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
- 8. Transmissions
   + 8.1.2. Specifications
   - 8.2. Automatic transmission
      8.2.2. Specifications
      8.2.3. Diagnostics of automatic transmission
      8.2.4. Draft of the selector of transmission
      8.2.5. kick cable - down - the mode
      8.2.6. The blocking backing signal switch/switch
      8.2.7. Removal and installation of transmission
      8.2.8. Epiploons of automatic transmission
      8.2.9. "Automatic machine"
+ 9. Coupling
+ 10. Brake system
+ 11. Running gear
+ 12. Body
+ 13. Electric equipment
+ 14. Useful tips



8.2.4. Draft of the selector of transmission

Adjustment

PERFORMANCE ORDER
1. Lift the car. It is required to shoot the exhaust system and a thermal guard with parts of cars.
Transmission 3HP 22
2. Remove a bracket of a clamp of draft of the selector and disconnect draft of the lever of the selector.
For this purpose remove a bracket (1) from a clamp (2), having pulled a bracket for the upper edge, and then having given down.
3. Take away the selector lever on transmission to a limit, then displace in the opposite direction (forward) on 2 clicks. This situation corresponds to neutral.
4. In salon install the selector in situation N.
5. Ask the assistant to install the selector lever opposite to the limiter of situation N in a lock. Rotating a clamp on a carving tip of draft, establish it opposite to an opening in the lower termination of the lever of the selector. Truncate draft, having turned a clamp on 1–2 turns clockwise.
6. Establish draft on a clamp and check adjustment. For this purpose start the engine, press a pedal of a brake and transfer the transmission selector to all provisions.
Transmission of 4 HP of 22 N/EN
7. Install the selector provisions P.
8. Release a nut of fastening of a cable to the lever. On a part of cars the lever can be turned up, but not down, and carving fastening is replaced with an axis with the forelock.
9. Displace the selector lever towards the engine and give a cable tip in the opposite direction.
10. Attach a cable and tighten a nut.

11. Check adjustment. For this purpose start the engine, press a pedal of a brake and transfer the transmission selector to all provisions.

fb0c4883