BMW 3 Series E30

since 1983-1994 release

Repair and operation of the car



BMW E30
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engine
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
- 8. Transmissions
   + 8.1.2. Specifications
   - 8.2. Automatic transmission
      8.2.2. Specifications
      8.2.3. Diagnostics of automatic transmission
      8.2.4. Draft of the selector of transmission
      8.2.5. kick cable - down - the mode
      8.2.6. The blocking backing signal switch/switch
      8.2.7. Removal and installation of transmission
      8.2.8. Epiploons of automatic transmission
      8.2.9. "Automatic machine"
+ 9. Coupling
+ 10. Brake system
+ 11. Running gear
+ 12. Body
+ 13. Electric equipment
+ 14. Useful tips
fb0c4883


8.2.8. Epiploons of automatic transmission

Replacement

PERFORMANCE ORDER
Hydrotransformer epiploon
1. Remove transmission and the hydrotransformer (see subsection 8.2.7).
2. Check a condition of the plug of the hydrotransformer. If the plug is strongly worn-out, then replace the hydrotransformer, small damages of the plug try to remove them with a small skin.
3. Carefully get an epiploon adaptation.
4. Grease edges of a new epiploon with liquid and press the mandrel resting against an external part of an epiploon.
5. Install the hydrotransformer. Track that it completely came into gearing with the pump (turn the hydrotransformer, pushing). Further assembly is carried out upside-down.
Transmission selector lever epiploon
6. Lift the car.
7. Remove the lever from a transmission shaft, without disconnecting draft.
8. Carefully get an epiploon adaptation or the small screw-driver.
9. Grease edges of a new epiploon with liquid and press the mandrel resting against an external part of an epiploon.
Transmission shaft epiploon
10. Lift the car.
11. Remove exhaust pipes and the driveshaft (see subsection 9.10).

12. Unbend kontrovochny teeth of a lock washer and turn off a nut. Remove a flange.

13. Grease edges of a new epiploon with liquid and press the mandrel resting against an external part of an epiploon. Dress a flange and tighten a nut, having greased with sealant its internal surface. Further assembly is carried out upside-down.

General instructions

After replacement of any of epiploons check the level of transmission liquid, if necessary restore.